search

bigtreetech / BIGTREETECH-Relay-V1.2

BIGTREETECH Relay V1.2 is an upgrade of the original (BIGTREETECH V1.0). After upgrading, a small MCU was added on the module to make the module more controllable and stable. Besides, we have also increased short circuit detection circuit. After connecting the 5V and GND on the motherboard to the module, if there is a 5V short circuit, the module will immediately power off to prevent damage on the motherboard and the risk of fire caused by short circuit.
122 stars 27 forks source link

BTT Relay V1.2 on BTT SKR Mini E3 V1.2 Installation #12

Open Timbonade opened 4 years ago

Timbonade commented 4 years ago

Hello, I have now read through some error descriptions, but I am not so sure how to connect the relay to my SKR Mini E3 V1.2. I installed a touchscreen and a BL Touch. Where should I connect the relay now? And which pin is it then that I have to know to indicate it in the firmware.

Sorry for my bad English, I'm from Germany.

Hallo, ich habe mir hier jetzt einige Fehler beschreibungen durchgelesen, doch so ganz sicher bin ich mir nicht, wie ich das Relay jetzt an mein SKR Mini E3 V1.2 anschließen muss. Ich habe Ein Touchscreen und einen BL Touch verbaut. Wo sollte ich jetzt das Relay anschließen? Und welcher pin ist es dann, dass muss ich ja wissen um es in der Firmware an zu geben.

th0547 commented 3 years ago

Hello!

I'm also installing it on a SKT mini E3 V1.2 and I have it installed, I only need to fix it turning of after ~30 seconds. I'll share with you how I have installed but I'll make it a bit graphical so it's easier to understand. I'll post it tomorow

maroca2177 commented 3 years ago

¡Hola!

También lo estoy instalando en un SKT mini E3 V1.2 y lo tengo instalado, solo necesito arreglarlo apagándolo después de ~ 30 segundos. Compartiré con ustedes cómo lo he instalado, pero lo haré un poco gráfico para que sea más fácil de entender. Lo publicaré mañana

Puedes mandar como lo instaslate?? En esa placa por favor

maroca2177 commented 3 years ago

Puedes mandar como lo instalaste por favor, gracias

vyacheslav-moiseev commented 3 years ago

Hello!

I'm also installing it on a SKT mini E3 V1.2 and I have it installed, I only need to fix it turning of after ~30 seconds. I'll share with you how I have installed but I'll make it a bit graphical so it's easier to understand. I'll post it tomorow

Hi ! Were you able to hook this up?