The closed-loop drive is to feedback the rotation angle of the stepping motor to the control panel, compare the distance that needs to be rotated with the distance of the actual rotation, calculate the error value, and then compensate, so as to prevent the problem of multi-step and lost step. The closed-loop drive can completely overcome the lost step of the open-loop stepping motor, and can also significantly improve the performance of the motor at high speed
25
stars
8
forks
source link
Data display abnormal, and hard to comunicate serial port #3
Dear,
I bought two of these motors for x and y axises, when I turn off my printer I move x and y axises, after that one of my mortor display can't turn on and serial port broken. I try to remove closed loop driver and check magnet, magnet still in thé center. I try to upload code again but i need press reset button many times for computer recognizes boad, and green light on board on and fade slowly. I think something broken, someone help me identify which broken for me to replace component on this board, thank you so much.
Dear, I bought two of these motors for x and y axises, when I turn off my printer I move x and y axises, after that one of my mortor display can't turn on and serial port broken. I try to remove closed loop driver and check magnet, magnet still in thé center. I try to upload code again but i need press reset button many times for computer recognizes boad, and green light on board on and fade slowly. I think something broken, someone help me identify which broken for me to replace component on this board, thank you so much.