Closed Pretous closed 3 years ago
Pull request #70 fixes this.
Pretous, I will compile a firmware for you if you tell me what your setup is (including all mods)
TXT4NK would you compile a firmware for me? Ender 3 E3 DIP V1.1 TFT35 v3.0 TMC2209 Drivers all stock besides that
Sure, ill compile it tomorrow morning when I get to work.
Thank you!
Sure, ill compile it tomorrow morning when I get to work.
Have you gotten the chance today?
Im sorry, today turned out to be an absolute circus at work. I'll get it done tomorrow.
This should do the trick. While you update your board firmware, I would also update the TFT's firmware if you haven't already. Below is a link to BTT's guide on updating firmware, and a link to a zip file with the project files and a pre-compiled firmware binary file for you.
https://github.com/bigtreetech/BIGTREETECH-TouchScreenFirmware
txt4nk Thanks! you are the best!
No problem
txt4nk The stepper motors are backwards and there is no jerk...
I'll reverse the steppers tomorrow. Can you verify if the extruder is reversed please
Yes the extruder is backwards too
Give this one a shot.
Sorry for the late reply. That worked well. Thatnk you again! You should make this available for everyone.
Sorry for the late reply. That worked well. Thatnk you again! You should make this available for everyone.
I have added repo's on my github for my personal printers. I will start to do that for these builds that I do for you guys as well, when time permits of course. Hard to find time when I work 70+ hours a week.
@Pretous
The reported issue is solved. Please close this ticket.
Thank you
@bigtreetech
Please close this ticket
Please help the community and close the ticket once you do not need it anymore. Thank you
Hello, i know this software work for V1.1 too, but you can add any notification about it. I spent whole day to find that software from V1.0 fit for V1.1