search

bigtreetech / BIGTREETECH-SKR-E3-DIP-V1.0

BIGTREETECH SKR-E3-DIP-V1.0 motherboard is launched by the 3D printing team of Shenzhen BIGTREE technology co., LTD. This board is specially tailored for Ender 3 printer, perfectly replacing the original Ender3 printer motherboard.
130 stars 111 forks source link

Are the servo pins labeled right on the diagram? #76

Closed Grayfox2005 closed 4 years ago

Grayfox2005 commented 4 years ago

I was troubleshooting the Geeechtech 3D Touch probe and wired it according to the DIP pin diagram, PA1, GND, +5V, the board is dead. When I wire it PA1, +5V, GND, it functions properly. Either the board diagram or the probe is incorrect. I checked the voltage coming off the DIP board and it does show the middle pin as having +5 volts and the end pin having zero.

Grayfox2005 commented 4 years ago

Never mind. I thought I was getting the 1.0 board from amazon that they advertised but after I looked and seen that the 1.1 board made the servo change I looked more closely at my board and it is in fact a 1.1. Sorry, my bad.