Closed tome9111991 closed 3 years ago
you have enabled steathchop and sensorless homing in the firmware?
Yes maybe i found the issue. I comment
#define USE_XMIN_PLUG
#define USE_YMIN_PLUG
Im back to default it works now but not well.
With 90 STALL SENSITIVITY he moves a little bit hard to endstop. With 91 STALL SENSITIVITY he moves 2-3mm and then is homed but not reach the endstop.
Im back to Sensor homing.
Hi there.
X and Y axis sensorless homing does not work.
The bed does not stop moving along the x and y axis when homing. I tried cranking the sensitivity all the way up to 255 but it still wouldn't stop at all. Any advice?
Jumper for X and Y Diag are in