After I home the Z axe the printer is going to center to go down, after reaching the middle, it starts to go down a few cm and then goes up without stopping, as a probe im using an button NO with an semi manual deployment, I have to push it down and it locks in place for bed leveling, after that to the end of the X axe is an T structure that pushes an buton to retract, the printer was an XYZprinting and it came with this tipe of probe, and also when I start to home, the Z axe is going down a few cm instead of upp, the axe is inverted but it doesnt matter If I trigger the button nothing changes.
After I home the Z axe the printer is going to center to go down, after reaching the middle, it starts to go down a few cm and then goes up without stopping, as a probe im using an button NO with an semi manual deployment, I have to push it down and it locks in place for bed leveling, after that to the end of the X axe is an T structure that pushes an buton to retract, the printer was an XYZprinting and it came with this tipe of probe, and also when I start to home, the Z axe is going down a few cm instead of upp, the axe is inverted but it doesnt matter If I trigger the button nothing changes.
Config: New folder.zip