Closed Defaultsound closed 4 years ago
Solved this issue. Turns out that the positions of the JST connectors were wrong. On the switch itself the pins are on the out most side of the connector. As the original motherboard used a 2 pin connector I had to replace them with 3 pin connectors for the SKR. However, putting them on the far most pins does not work. Instead you need to put them on the far most right side of the connector on the JST. Here is a picture to help demonstrate. https://imgur.com/gallery/bMtPcU0
Hi, Please help if you are using mechanical endstop, then Please kindly share latest your updated marline 2.0.
Hi,
So I'm currently trying to replace my Creality CR10 S5's motherboard with a SKR 1.4 Turbo. I purchased this along with TMC 2208 v3 Drivers. So far I've got most things working, from the motors to temperature sensors etc. However the endstops just won't communicate with the board.
I've got X,Y,Z endstops all plugged in. Using 1.29 for X, 1.28 for Y and 1.27 for Z. Pressing the endstops and sending M119 through Pronterface does not display or show a change in its state. I haven't the slightest clue to why this is happening. I've check the switches for continuity and they all work. So I'm left to believe I'm missing something in the Configuration.h files.
Any help would be greatly appreciated!
Configuration.h
Configuration_adv.h