Problem with stepper motor drivers skr 1.4 turbo

bigtreetech / BIGTREETECH-SKR-V1.3

32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required

1.01k stars 1.15k forks source link

Problem with stepper motor drivers skr 1.4 turbo #312

Open Gabe1231 opened 4 years ago

Gabe1231 commented 4 years ago

I bought a skr 1.4 turbo and some tmc2209 stepper motor drivers from bigtreetech and after the firmware was configured the steppers were loud and noisy. so I compiled more firmware to try to fix the problem, and the LCD went blank. can anyone tell me how to fix this to how to contact btt?

Isaac12x commented 4 years ago

It will pretty much depend on what printer you have and what you have modified in the configuration.h file.

Isaac12x commented 4 years ago

However, I'm assuming here, if you have a Creality printer uncommenting the line #define CR10_STOCKDISPLAY will do.