32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
I recently upgraded my custom i3 to a full set of LDO motors and they are getting up to 80C while printing. I've been asking in Discords, the BTT Facebook group and Twitter and no one seems to know what the cause is.
I'm using a SKR 1.3 with BTT TMC2209 V1.2 drivers in UART mode and Sensorless homing on X and Y. Attached is my config.h and config_adv.h.
I recently upgraded my custom i3 to a full set of LDO motors and they are getting up to 80C while printing. I've been asking in Discords, the BTT Facebook group and Twitter and no one seems to know what the cause is.
I'm using a SKR 1.3 with BTT TMC2209 V1.2 drivers in UART mode and Sensorless homing on X and Y. Attached is my config.h and config_adv.h.
Configuration.zip