Open bitfabrikken opened 4 years ago
Did you ever figure out the jumper settings? I have also been looking for this and haven't found anything.
@ShaneDelmore It worked fine for me like mentioned above, no jumpers anywhere, except one on E0. Note that I'm not using E1 for the 2nd Z, both z motors are on the Z port.
Hi, I can't find much info anywhere on how to set jumpers for using TMC2100 drivers (the stock ones on Artillery Sidewinder X1).
I've seen a few reddit comments say to have no jumpers anywhere, except on E0 (shown in image below).
Can someone help?