32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
It's been less than two months that i got my SKR v1.4 Turbo and 4 TMC2209. Bought the hardware for my ender 3.
Today i was print a part for my job and left the printer printing in another room,. After 2 hours as i was working on the PC i smelled smoke than i went to check on the printer, when i got to the room the Y axis TMC 2209 was smoking a lot. I turned everything off. After dissamsemble i got a dead SKR v1.4 turbo and 2 burned TMC 2209 as you can see in the pictures bellow. Very sad upgrade :( my PSU seems fine still supplying 24V, fuses on the SKR are fine, but the board and the drivers are dead, don't know if Z axis and Extruder drivers are fine, but they dont seem to be burned as the others.
It's been less than two months that i got my SKR v1.4 Turbo and 4 TMC2209. Bought the hardware for my ender 3.
Today i was print a part for my job and left the printer printing in another room,. After 2 hours as i was working on the PC i smelled smoke than i went to check on the printer, when i got to the room the Y axis TMC 2209 was smoking a lot. I turned everything off. After dissamsemble i got a dead SKR v1.4 turbo and 2 burned TMC 2209 as you can see in the pictures bellow. Very sad upgrade :( my PSU seems fine still supplying 24V, fuses on the SKR are fine, but the board and the drivers are dead, don't know if Z axis and Extruder drivers are fine, but they dont seem to be burned as the others.