[GUIDE] No update from SD solution?

bigtreetech / BIGTREETECH-SKR-V1.3

32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required

1.01k stars 1.15k forks source link

[GUIDE] No update from SD solution? #423

Open borsegbr opened 4 years ago

borsegbr commented 4 years ago

Possible solution to repair no update from SD Contains guide and original dump from skr 1.4 turbo

Flash skr1.4.zip

gdanas87 commented 4 years ago

YOU ARE A LIFESAVER!!!! I am pulling my hair out for the past 4 days trying to figure out how I will flash new fw to my skr1.4, since I damaged the sd slot upon inserting the sd on initial startup when I unboxed the board (gotta admit, i have never had this happed to me before on any other board or device before in my life, so the sd slot is definately of totally crappy quality!!!) Works just fine with an ftdi adapter btw, instead of the btt writer which i dont have. again, You are a lifesaver!!! Thank you so much, I have found a way to put my "broken" board to good use!!!

BerkhanB commented 3 years ago

Just a quick note: I was going to follow this procedure but just tried another SD card before buying an FTDI adapter, it just worked. Try a new SD card before using this guide.

Frix-x commented 3 years ago

In my case, the board was sold without any bootloader or firmware pre-flashed in factory: the board was not recongnized by my computer (nothing happened when plugged by USB) and the firmware.bin was not flashed from SD card....

After trying multiple methods to flash a new firmware to my suspected dead SKR 1.4 Turbo without any luck, your method finally make me able to do it with my FTDI adapter !

Thank you very much !!!