32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
Hi all. Firstly I am new to printing and I've looked for the answer to this really I have, but for a newbie it's confusing.
I have the SKR Pro board with 2130 divers, I've compiled marlin and flashed using the SD card.
The cards firmware file goes from .bin to .cur so I know it's been updated. I have the TFT70 screen and this works fine.
The drivers will not move the steppers, no matter what I do.
Does anyone have a complete firmware file that I can use?
I'm about to give up with these drivers and this board as there just not a lot of info out there on it.
Hi all. Firstly I am new to printing and I've looked for the answer to this really I have, but for a newbie it's confusing.
I have the SKR Pro board with 2130 divers, I've compiled marlin and flashed using the SD card. The cards firmware file goes from .bin to .cur so I know it's been updated. I have the TFT70 screen and this works fine.
The drivers will not move the steppers, no matter what I do.
Does anyone have a complete firmware file that I can use?
I'm about to give up with these drivers and this board as there just not a lot of info out there on it.