32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
1.01k
stars
1.15k
forks
source link
Extruder T1 does not work on Smoothieware SKR1.3 #436
If you assign pins
extruder.hotend2.step_pin 0.1 # Pin for extruder step signal
extruder.hotend2.dir_pin 0.0 # Pin for extruder dir signal
extruder.hotend2.en_pin 0.10 # Pin for extruder enable signal
epsilon_current
then the second extruder does not work on the T1 command.
With the same firmware on SKR 1.4 and MKS SGEN everything works (I assign pins in the same way as the board).
What's the problem with pins on skr 1.3?
If you assign pins extruder.hotend2.step_pin 0.1 # Pin for extruder step signal extruder.hotend2.dir_pin 0.0 # Pin for extruder dir signal extruder.hotend2.en_pin 0.10 # Pin for extruder enable signal epsilon_current then the second extruder does not work on the T1 command. With the same firmware on SKR 1.4 and MKS SGEN everything works (I assign pins in the same way as the board). What's the problem with pins on skr 1.3?