32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
My bltouch suddenly stopped working without any wiring or firmware change. No fix is working found all over the internet.
I just measured the voltage when sending m280 P0 S10. And the voltage over servo P2_00 to servo gnd stays 0. Can anyone confirm that this means that my mainboard pin broke of the servo control?
Hi all,
My bltouch suddenly stopped working without any wiring or firmware change. No fix is working found all over the internet. I just measured the voltage when sending m280 P0 S10. And the voltage over servo P2_00 to servo gnd stays 0. Can anyone confirm that this means that my mainboard pin broke of the servo control?
thanks in advance