Cant add more than 3 drivers

[vinoudropdrop]

Hi! I'm something like noob with 3d printing and configurate it. First, about the configuration :

• SKR v1.4 Turbo
• Marlin 2.x bugfix
• RepRapDiscount Full Graphic Smart Controler
• 5x : DRV8825 v2.0 BTT ( with E1 as dual Z by modify line #define NUM_Z_STEPPER_DRIVERS 2 in Configuration_adv.h)
• 5x : 17HS4401
• PSU : Leadstar S-360-24 (24v/15A)
• Jhead v6
• Redrex Dual Drive extruder
• Hotbed not connected at this time And, I have an issue. When I try to plug more than 3 drivers, nothing move. If I plug only one, two, or three drivers whatever if it is on X, Y, Z, E1 or E2, I can move stepsmotors. But if I plug 4 or all the 5 drivers in, no one motor move again. I have searched in the issues there, and I didn't found any result to help me. Have you an idea about what to check?

[vinoudropdrop]

Ok, I found the mistake. All jumpers behind steppers were on the right (capacitor side). Jumped all to the left and now it work! I close the Issue