X axis stalls wont travel / home

bigtreetech / BIGTREETECH-SKR-V1.3

32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required

1k stars 1.15k forks source link

X axis stalls wont travel / home #450

Closed iHover01 closed 3 years ago

iHover01 commented 3 years ago

I just installed SKR V1.4 Turbo board with TMC 5160 stepper drivers on all axis. when I home all the axis work fine except for the x axis. it begins moving to home but stops traveling after moving a 10-20 mm. If I move it close to the switch it it homes but it I try bed leveling following that it has the same behaviors, it moves a few mm and then stops. I have all the TMC settings for this axis setup the same as the Y axis which works without any issues.

mpapam commented 3 years ago

Have been trying for hours and hours to make my TMC5160 to work on SKR without any success, no movement at all. Can you please share your configuration.h and configuration_adv.h files along with your hardware setup? Regarding your issue I suggest you exchange drivers with Y or Z axis to see whether it is a faulty driver issue

iHover01 commented 3 years ago

Sorry though I closed this. It appears to have been an issue with a cable