search

bigtreetech / BIGTREETECH-SKR-V1.3

32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
1k stars 1.15k forks source link

SKR V1.4 Turbo doesn't connect via USB #458

Open Trytas opened 3 years ago

Trytas commented 3 years ago

Hey guys,

I got myself a SKR 1.4 turbo and I'm allready 3 days working on the damn thing and can't get the USB Connection to work In my opinion the firmware is setup the right way and should work

https://www.dropbox.com/s/wqu2cb1aiu05r8g/firmware.bin?dl=0

I tried everything now I could find on YT

Trytas commented 3 years ago

https://www.dropbox.com/sh/9aahv5hq3sb2f3z/AACnUjZ77FrZzDNp9NcebgmOa?dl=0

Here is the complete Folder if anyone needs it

tarifari commented 3 years ago

maybe your usb "thing" is burned. I have two boards with same issues.

https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/issues/50

Maybe this helps. Try to solder out D3.

I´ll try it today and will report my results

Trytas commented 3 years ago

Would be great Would like to use the USB because I'm not really in the mood the upload everything on the SD and put it into the printer

tarifari commented 3 years ago

is it just the usb connection? can you control the printer? my display also says "no printer attached" so i dont know if its just the usb connection. Cant control the printer too

Trytas commented 3 years ago

The printer work's just fine if controlled over the Display. So I need to put the gcodes on my SD card and then start the print over the Display. At the moment I'm using the stock CR-10 display