32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
Hello!
I am using an SKR V1.4 Turbo + the latest bugfix marlin offered here.
No matter the slicer or the settings, my prints always start with an offset on the first layers to the left. It forms between the wall and the infill. This is not overlap, I checked. It is not a jump of the head either because the layers above return well to the starting point. Any ideas?
Hello! I am using an SKR V1.4 Turbo + the latest bugfix marlin offered here. No matter the slicer or the settings, my prints always start with an offset on the first layers to the left. It forms between the wall and the infill. This is not overlap, I checked. It is not a jump of the head either because the layers above return well to the starting point. Any ideas?