Open bywebberen opened 3 years ago
And when I do a M119 after the Error it says that probe is TRIGGERED, but it isn't (inverting perhaps) but it works for G28 ?
Got It working ONE time after reflashing, but I only reflashed because i couldn't get the SKR v1.4 to boot up after I had it turned off while getting a bite to eat ... But second time i ran the same GCODE it just did the G28 Tried to do the G29 Errored and went on with the startup sequence of the printing... I am loosing patience with this V1.4 ! ! ! 👎
Just Found out that when it says this "false" triggered - I cant trigger the Inductive probe manually?? It doesn't light up ? Is it possible that it pulls it down or up, different when probing and homing?
Soldered the 2 of the 3 pads missing the 0ohm resistor together, UART now works with M122 no errors, but now it wont do a G29?
G28 works fine, but when I test G29 it lowers my bed, like its already triggered and POSTS error Probing?
Any ideas
Marlin 2.0.7.2