32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
1k
stars
1.15k
forks
source link
Anet a8 plus on TMC 2208 drivers make a squeak, and do not move #478
Anet a8 plus on SKR v1.4 TMC 2208 drivers / Bought on Anet A8 plus Anet a8 plus on TMC 2208 v2. 0 drivers tell me how to put jumpers under the drivers on the Board? I tried many configurations for the marlin firmware. But in some cases, it doesn't compile. With a successful compilation after flashing, the Axes move by 1 mm and start to make a squeak, and do not move
. If you lower the speed of movement, the engines make a lot of noise but move. When Parking the Z-axis reaches the zero point, it rests on the button and stops, there is no rollback.Please help me, when rearranging jumpers in the right row, I tried to lower the voltage, but it did not give any results!
By the way, the driver on the Z axis is very hot (I did all the tests on the Z axis)
Conf.zip
With this configuration, everything moves as it should, perfectly. But there is one but! When the carriage is moved by 1 cm programmatically via the printer control when measuring, it is actually moved by 1.3 cm. A 2x2x2 cube turns out to be X2. 4 Y2. 4 Z2. 0
Conf2.zip
Anet a8 plus on SKR v1.4 TMC 2208 drivers / Bought on Anet A8 plus Anet a8 plus on TMC 2208 v2. 0 drivers tell me how to put jumpers under the drivers on the Board? I tried many configurations for the marlin firmware. But in some cases, it doesn't compile. With a successful compilation after flashing, the Axes move by 1 mm and start to make a squeak, and do not move . If you lower the speed of movement, the engines make a lot of noise but move. When Parking the Z-axis reaches the zero point, it rests on the button and stops, there is no rollback.Please help me, when rearranging jumpers in the right row, I tried to lower the voltage, but it did not give any results! By the way, the driver on the Z axis is very hot (I did all the tests on the Z axis) Conf.zip
With this configuration, everything moves as it should, perfectly. But there is one but! When the carriage is moved by 1 cm programmatically via the printer control when measuring, it is actually moved by 1.3 cm. A 2x2x2 cube turns out to be X2. 4 Y2. 4 Z2. 0 Conf2.zip