search

bigtreetech / BIGTREETECH-SKR-V1.3

32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
1.01k stars 1.15k forks source link

1.4 turbo - blank screen on firmware compile #547

Open sdrulik opened 3 years ago

sdrulik commented 3 years ago

Hello, I've ran into a peculiar issue where I get a blank screen on compile for my Ender 3. I used the guide to set up TMC 2209 drivers, sensorless homing, BLTouch, Z probe homing, and using the servos/probe for the BLTouch. Using Marlin 2.09 and the latest Ender 3 1.4 configuration from marlin. https://media.githubusercontent.com/media/GadgetAngel/SKR-V1.4-Turbo-Stepper-Driver-Jumper-Configuration-Manual/master/CURRENT-Manual/SKR%20V1.4%20TURBO%20Stepper%20Driver%20Jumper%20Configuration_version%20V4.0_reducedFileSize.pdf

Here are my config.h and config_adv.h files.

Configuration - Copy.txt

Configuration_adv - Copy.txt

I'm not sure what is wrong and if maybe my BLtouch wiring is wrong? I was given a 5 pin connector and not 3+2 pin connectors. My wires also are different colors (blue, red, yellow, white, black). I wired them by removing the 5 pin and converting it to 3+2 connector in the following wire order:

BLTOUCH wiring left -right (white, black, yellow. red. blue) Servos port wiring left-right (white, black, yellow) probe port wiring left-right (red, blue)

Thanks!

radek8 commented 3 years ago

For Chinese 3Dtouch clones, it is not the color of the wire that matters, but the order of the contacts in the connector

look at the picture

https://github.com/KevinOConnor/klipper/issues/3574

picknell commented 2 years ago

i basically did the same setup. it happened few times. that a firmware i did went fine, compiled a new one with minor change, without change to cabling and with the new version it got stuck on the blank screen. Configuration.txt Configuration_adv.txt here are my files for the last working version if it helps. got it working with trianglelabs 3d touch using the dedicated bltouch slot. I think after all I solved it i think with formating the sd card, placing the bin file on it again and before taking the card out I used the safely remove feature on windows. Seems like that was the issue, not those minor changes between firmware.

Hetothet commented 8 months ago

i am struggling with the exact same issue i manage to get a working screen and menu using the ender 3 pro profile but z axis homing did not work with the bl touch nor the endstop