BTT Octopus V1.1 Running TMC2209 in UART mode and cannot get my dual Z steppers and E0 to run independently

bigtreetech / BIGTREETECH-SKR-V1.3

32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required

999 stars 1.15k forks source link

BTT Octopus V1.1 Running TMC2209 in UART mode and cannot get my dual Z steppers and E0 to run independently #553

Closed jmarkscnc closed 2 years ago

jmarkscnc commented 2 years ago

I have been working on this issue for way to long, but I have 2- Z motors and the E0 all move at the same time? I have check everything I can think of, config.h, config_adv_h, along with the pins file along with watching about 40 hours of videos that have nothing to do with this board with no success. I have uploaded my Marlin build to my shared folder on One Drive if anyone can look it over or make some suggestion, I would be very much appreciated.

https://1drv.ms/u/s!An3HLl2sqsgkiGBMwvWDTJpdLMDs?e=rRv7Om

radek8 commented 2 years ago

Do you have a Octopus V1.1 board? You're writing to the wrong repository. The problem of SKR 1.3 and SKR 1.4 boards is solved here

radek8 commented 2 years ago

Close the question and publish in the right place https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0/issues

jmarkscnc commented 2 years ago

Closing and moved this to the correct repository. Thank you I was doing a lot of searching and post this in the wrong place. Moved to; https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0/issues