32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
999
stars
1.15k
forks
source link
Seeking Help Compiling Marlin Firmware for Anet A8 with Tatara Frame and SKR 1.4 Turbo #582
Seeking Help Compiling Marlin Firmware for Anet A8 with Tatara Frame and SKR 1.4 Turbo
Hello everyone,
I'm reaching out for assistance in compiling the Marlin firmware for my upgraded Anet A8 with a Tatara frame. I've also integrated a BigTreeTech SKR 1.4 Turbo board and several other components. Here's a breakdown of my setup:
Motherboard: BigTreeTech SKR 1.4 Turbo
Display: BigTreeTech TFT70 V3.0
Endstops: Mechanical for X and Y, BLTouch for Z
Thermistors: 100k for both the hotend and bed
Extruder: Dual Drive Bowden System
Stepper Motors: TMC2130 in SPI mode
Axis Configuration: Dual motor for the Z-axis
I'm encountering some challenges in the firmware compilation and configuration, particularly regarding [specify the issues you're facing, e.g., "BLTouch setup", "motor calibration", etc.].
Additionally, I'd appreciate if anyone could guide me on the correct wiring for the stepper motors. I'm unsure about the correct sequence of the wire colors and how to properly connect them to the SKR board.
If anyone has insights or advice on setting up these specific components with Marlin, I'd be deeply grateful for any guidance.
Thank you so much in advance!
Seeking Help Compiling Marlin Firmware for Anet A8 with Tatara Frame and SKR 1.4 Turbo
Hello everyone, I'm reaching out for assistance in compiling the Marlin firmware for my upgraded Anet A8 with a Tatara frame. I've also integrated a BigTreeTech SKR 1.4 Turbo board and several other components. Here's a breakdown of my setup: