search

bigtreetech / BIGTREETECH-SKR-V1.3

32bit board with LPC1768, support marlin2.0 and smoothieware, support lcd2004/12864, On-board TMC2130 SPI interface and TMC2208 UART interface no additional wiring is required
999 stars 1.15k forks source link

hardware problem? #65

Open FCosta1 opened 4 years ago

FCosta1 commented 4 years ago

Hello.. I have a strange issue.. When i connect the skr 1.3 via USB the PC detects and the microSD appears and everything works ok... When i connect 24v i loose comunication with the pc... But.. If i press the reset button.. The USB works again... The board only works when i press the reset button.... But... After 1m ou so.. The board loose comunication again...

Hardware fault??

FCosta1 commented 4 years ago

I quit this board... Put original firmware.. Connect the USB cable and 24v power supply.. Loose connection with the pc... Connect only USB with lcd2004 and original firmware...

Appears: TMC CONNECTION ERROR...?????

Without doing nothing.... Without doind any changes in marlin....

I quit this

korttwulfe commented 4 years ago

There is a jumper near the middle of the board that says INT +5v USB. When powering with your Power supply (not usb) make sure the jumper is on the INT side.

FCosta1 commented 4 years ago

I tried both ways and nothing...

xoniq commented 4 years ago

Have you had the board up and running already once? Or is this a new experience? What stepper drivers are you using?

Also, when testing, do you have heat sensors attached? When I just got the board, I got crazy that the board stopped working after starting up, and it was because I had a test setup, but no temperature sensors attached so it shut down because of no temperature reading.

FCosta1 commented 4 years ago

The board only worked or by usb to access sdcard or by 24v to really work... There is a component that is dead.. Waiting for it to swap to see if the problem is from that or is really dead the board... The component is: MC74HCT125ADTR2G

The stepper driver is tmc2208 uart v1.2 from fysetc