Closed Chak10 closed 4 years ago
Unfortunately not as both are connected to the 24 V power supply directly.
You can, however, add the resistor in series with the fan (the same as it is inside the "Noctua low-noise adaptor". Be careful to size it properly according to the fan current consumption.
@bojanpotocnik Thanks for the reply. I was thinking of using two potentiometers.
Hi Sorry for commenting on the closed issue. The fans are too noisy. Is it possible to use the below PWM marlin codes to slow down the fan? //#define FAN_MIN_PWM 50 //#define FAN_MAX_PWM 128 These are commented out in configuration_adv.h. Or its not at all possible as the fans are connected to 24V supply directly ?
The noise is much higher than the stock, perhaps reducing speed would be better.