search

bigtreetech / BIQU-B1

147 stars 105 forks source link

Correcting Type-C plug hole size on back cover #36

Open philibertc opened 2 years ago

philibertc commented 2 years ago

On the 3d model "type C inferface protection", the hole for the type C plug was too small to fit the connector. Here is the corrected file.

thisiskeithb commented 2 years ago

The B1 hotend has gone through some revisions over the years, so I’d recommend adding this as a new variant instead of replacing the old one.

philibertc commented 2 years ago

Hello, this is not the protection for the hotend but the model to be fixed on the back, to limit the risk of bending the usb c connector. The only modification is the enlargement of the hole to pass the connector, which was much too small.