Closed Wombat37 closed 2 years ago
Tidying up!
Now I understand BTT's position of offering boards that support firmware like RepRap available from other developers, it's inappropriate to expect them to make fixes to that software.
When I bought this board, I thought I was buying a complete product - not just part of it :)
Closing this out, now...
I'm getting a bit cautious about entering more issues but I think this one is clearly wrong and should be working properly.
I'm running a BTT-E3_RRF v1.1 board with a BTT-E3-TFT35 v3.0 under RepRap 3.2.2. When I use the DWC to upload and run a print, I see strange and conflicting information on the print height and layer statistics.
See the annotated DWC screen capture below of an active print generated by Cura 4.9.0 and uploaded and run by DWC.
When this screen capture was taken, the print was currently at layer 84 - which was correctly reflected in one position of the display. The running chart showing layer timings showed that it was at layer 40 and this value was actively being updated.
Finally, the displayed print total height was displayed as 10mm with 50 layers - these values seemed to be displayed for anything being printed.
Clearly, there's misinformation here.