Open slowmosquito opened 2 years ago
Hello
i have a bigtreetech e3 rrf installed on ender3
it works ok , also wifi works ok and all is very well
i installed a bltouch and enabled on firmware marlin the auto bed level.
When i give auto level command the pronter starts procedure but stops at first point
Attached a txt file with debug, i see the error no trigger
i definied this #define Z_MIN_PROBE_PIN 32 // Pin 32 is the RAMPS default
The bltouch probe is connected to Z PROBE 5 pin
i attach also configuration.h (on txt format) file
any suggestion aprecied
thanks debug.txt Configurationh.txt
Hello
i have a bigtreetech e3 rrf installed on ender3
it works ok , also wifi works ok and all is very well
i installed a bltouch and enabled on firmware marlin the auto bed level.
When i give auto level command the pronter starts procedure but stops at first point
Attached a txt file with debug, i see the error no trigger
i definied this #define Z_MIN_PROBE_PIN 32 // Pin 32 is the RAMPS default
The bltouch probe is connected to Z PROBE 5 pin
i attach also configuration.h (on txt format) file
any suggestion aprecied
thanks debug.txt Configurationh.txt