Open Giorgiofossati opened 2 years ago
What ls /dev/serial/by-id/ show? What MCu are you using?
@shawnchr
MCu is an AtMega 2560
OK I am not sure you can use anything but a BTT board. There is supposed to be new image coming maybe it will work then in the mean have tried recreating firmware on the PI4B+CB1 and reflashing MCU not sure it will work but might try it. Lots off issue with this board and software.
@shawnchr
MCu is an AtMega 2560
More important is the type of UART->USB chip. For example CH340, PL2303, CP2102.
The drivers just might not be included in the system.
What does lsusb
say?
@frutabruta lsusb say this, it seem it could see usb devices…
@frutabruta lsusb say this, it seem it could see usb devices…
So CH340 it is. Try to install drivers using this tutorial: CH340 install
@frutabruta hi and thanks for the replies, I have not been able to install the CH340 drivers. see the images
same to me!
This is image https://github.com/bigtreetech/CB1/issues/29#issuecomment-1236130800 You will need to use nmtui via a monitor to configure wlan0 to get wifi connected the see if you can do your drivers.
I don't have any HDMI Monitor left over. nmtui can also run from command line. This is how I changed my network settings until now. the large hook is WEP3 not compatible. l must switch back to WEP2.
Hello, i'm using PI4B + CB1. I installed KIAUH , Klipper and Moonraker without problem, wifi work perfectly, but i can't connect to the printer the CB1 can't see the MCU wich was previously flashed with klipper. I need to reflash the MCU with some particular USB setting?