I do have a question regarding the EBB2240 boards. I do use a Rapido V2 hotend with a TWO wire PT1000 Thermistor. While looking for something else in the schematics I did notice that the board specifies a 4300R resistor while the Klipper docs specifies a 4700 Pullup resistor. Am I correct with my assumption that I do have to replace the 4700 default with the 4300? (I did set the dip switches to the PT1000 position before). I just want to make sure before I go ahead as this would mean a significantly higher temperature
I do have a question regarding the EBB2240 boards. I do use a Rapido V2 hotend with a TWO wire PT1000 Thermistor. While looking for something else in the schematics I did notice that the board specifies a 4300R resistor while the Klipper docs specifies a 4700 Pullup resistor. Am I correct with my assumption that I do have to replace the 4700 default with the 4300? (I did set the dip switches to the PT1000 position before). I just want to make sure before I go ahead as this would mean a significantly higher temperature