I have a question on whether or not I can connect a filament sensor to extra pins on my board.
I am using the tap mod so those pins and the x-limit switch is taken. I saw another post with a 2209 where someone said you could use the proximity switch pins if that is not in use, obviously signal and ground only. I just wanted to clarify that it would work (since I am using the tap) and not interfere with anything else or blow my board up.
That would save a ton of time wiring if possible.
Thanks
I have a question on whether or not I can connect a filament sensor to extra pins on my board.
I am using the tap mod so those pins and the x-limit switch is taken. I saw another post with a 2209 where someone said you could use the proximity switch pins if that is not in use, obviously signal and ground only. I just wanted to clarify that it would work (since I am using the tap) and not interfere with anything else or blow my board up.
That would save a ton of time wiring if possible. Thanks