search

bigtreetech / EBB

497 stars 107 forks source link

What is the pitch of the Pin Header Jumper Cap, so I can order a replacement jumper cap #15

Open GadgetAngel opened 2 years ago

GadgetAngel commented 2 years ago

What is the pitch of the Pin Header Jumper Cap for the EBB36 and EBB42 boards? My box spilled and I lost all the jumper caps. I need to order a replacement jumper caps but the jumper caps for the EBB36 are not 2.54mm pitch. What is the pitch for these jumper caps?

gielbloks commented 2 years ago

measure with a caliper / google pcb jumper spacings or something should be easy to find..

if you're in a rush.. carefully bridge them with a small drop of solder (one way action in most cases as it can be hard to remove an don't melt the plastic)

GadgetAngel commented 2 years ago

measure with a caliper / google pcb jumper spacings or something should be easy to find..

if you're in a rush.. carefully bridge them with a small drop of solder (one way action in most cases as it can be hard to remove an don't melt the plastic)

I tried the jumper cap with pitch 1.27mm but those are way too small. I just order some with a pitch of 2mm and I will post if those worked when they arrive

Edited: 9/7/222

Yes, the pitch is 2.0mm for the jumper caps on the EBB36 board

it also appears that the 4-pin MAX31865 PT100 connector is JST-PH type of connector it also appears that the 5-pin Endstops connector is JST-PH type of connector the heater connector for the hotend is screw terminal while the CAN connector is Microfit 3.0 dual row 4-pin connector while the other connectors (expect for the PIN headers) are JST-XHP type of connectors

gielbloks commented 2 years ago

or just bridge it with a drop of solder..

ey wait . there are enough crimp contacts in the set.. crimp 2 together and use it as a bridge.. surely for the time being/solder the 2 crimp connectors together and you will have a jumper..

groeten/regards

Giel Bloks

Vergert 81 6662DX ELST

From: JoAnn Manges @.> Sent: Friday, September 2, 2022 9:07:56 PM To: bigtreetech/EBB @.> Cc: Giel @.>; Comment @.> Subject: Re: [bigtreetech/EBB] What is the pitch of the Pin Header Jumper Cap, so I can order a replacement jumper cap (Issue #15)

measure with a caliper / google pcb jumper spacings or something should be easy to find..

if you're in a rush.. carefully bridge them with a small drop of solder (one way action in most cases as it can be hard to remove an don't melt the plastic)

I tried the jumper cap with pitch 1.27mm but those are way too small. I just order some with a pitch of 2mm and I will post if those worked when they arrive

— Reply to this email directly, view it on GitHubhttps://github.com/bigtreetech/EBB/issues/15#issuecomment-1235820129, or unsubscribehttps://github.com/notifications/unsubscribe-auth/APDVSXDXLCMOQ75A2LU3A2DV4JGAZANCNFSM6AAAAAAQB2VFIA. You are receiving this because you commented.Message ID: @.***>