search

bigtreetech / EBB

433 stars 100 forks source link

Printed_Part_for_CAN_Cable_v1.1.stl doesnt fit the newest can bus cable for SB2209 #89

Open cristianku opened 7 months ago

cristianku commented 7 months ago

Printed_Part_for_CAN_Cable_v1.1.stl doesnt fit the newest can bus cable for SB2209

meaning : 1- tried the Printed Part for CAN Cable.stl but it doesnt fit since its 6mm wide, while the canbus cable connector is 9mm 2- tried Printed_Part_for_CAN_Cable_v1.1.stl , it doesnt fit because there is no concavity or a hole below, to fit the usb-c connector that it goes a bit outside of the CW2 cable bridge

Zephyrus67 commented 6 months ago

Yes that is the same for me. Non of the cable holders fits the cable.

Westy69 commented 6 months ago

we got a fix over at the magic phoenix github printed files page. BUT .... it now looks like the new SB2209 boards are protruding up 3mm or more past the usb-C sTL. looks like BTT have now also changed the hole location on the SB2209 PCB and the board sticks up about 3mm past the base line of the USB port and you cannot clamp the canbus cable clamp V1.1 down. we are working on our own solution and now that the boards have different hole positions (raising the board up 3.0mm higher). looks like we need to mod it to something like this. https://cdn.discordapp.com/attachments/887546608563155024/1184910323615023144/image.png?ex=658db0bb&is=657b3bbb&hm=d9b119cdbccb2fa0161292c2ac9512e7a8d0a37d2f5d90207ebe4bcc8bf4efc9&