search

bigtreetech / Manta-M4P

46 stars 13 forks source link

Difference between v2.1 and v2.2 #25

Open asychev opened 11 months ago

asychev commented 11 months ago

Are there any significant difference between current v2.2 version and previous v2.1? In Hardware folder only 2.1 documentation available, can it be updated?

1954Doc commented 6 months ago

Same here.

Or. just tell us the technical information (pin ID's, signals, etc.) are the same so we can get on with debugging.

warpwookie commented 5 months ago

Agreed, the Chip ID is different on the V2.2 as well I've been trying to setup my V2.2 for about 3 days now and not having great luck. The Chip on my board is a G0B0 not a G0B1. could we get some support here???

warpwookie commented 5 months ago

I just flashed a new board because Mainsail said my klipper was out of date on the version that came out of the box version 10 something of klipper. So I flashed it using the G0B1 config and I cannot see it in lsusb or ls /dev/serial/by-id or by-path/ Help! the version of klipper I'm working with on my host is v0.12.0-128

satbe commented 5 months ago

Although v2.2 has the B0 STM32 Chip, the HW seems to be compatible with V2.1. I had to replace an M4P because of a dead analog input. The original version was 2.1, the new one was 2.2. I built the binary acording their manual (chose G0B1). I also updated Klipper before I built the binary. A full HW power cycle was necessary to update the M4P from flash. A Linux system restart was not enough. After that I got a new usb ID which I added to printer.cfg. My main mistake preventing the board to update from flash was to not HW power cycle.