If I use the TMC5160 HV/PRO controllers for X and Y, when I try G28, the bed moves down (Ender5) correctly, and then when the motors should move for movement in the X axis, an error pops up: Unable to write tmc spi 'stepper_x' register GLOBALSCALER. Properly connected to SPI and motor power set to VBB.
Tried 2 brands of TMC5160HV/PRO drivers: Bigtreetech and XinDongWang. and the 2 Manta M5P boards I bought behave the same way.
So the whole problem was in the disputed setting between HW SPI and SW SPI on the TMC and the display.
it was enough to correct the display settings on the SPI SW, see screen
If I use the TMC5160 HV/PRO controllers for X and Y, when I try G28, the bed moves down (Ender5) correctly, and then when the motors should move for movement in the X axis, an error pops up: Unable to write tmc spi 'stepper_x' register GLOBALSCALER. Properly connected to SPI and motor power set to VBB. Tried 2 brands of TMC5160HV/PRO drivers: Bigtreetech and XinDongWang. and the 2 Manta M5P boards I bought behave the same way.
printer.cfg.txt
klippy.log