I'm unable to get MIN1 (PD3) and MIN2 (PD2) to trigger in Klipper, using a configuration of 5 steppers (tmc5160).
MIN3 and MIN4 works.
M5P is configured with USB-to-CAN (PA11/PA12) and CAN on (PD0/PD1)
TMC51650 is configured for physical endstop (no jumpers installed on diag pins)
There is 3.3v between Signal & Ground pins on MINx ports.
Endstopswitch for testing is a microswitch in NC configuration.
Is this a board related issue or a Klipper issue ?
I'm unable to get MIN1 (PD3) and MIN2 (PD2) to trigger in Klipper, using a configuration of 5 steppers (tmc5160). MIN3 and MIN4 works.
M5P is configured with USB-to-CAN (PA11/PA12) and CAN on (PD0/PD1) TMC51650 is configured for physical endstop (no jumpers installed on diag pins) There is 3.3v between Signal & Ground pins on MINx ports.
Endstopswitch for testing is a microswitch in NC configuration.
Is this a board related issue or a Klipper issue ?