Hi I finally wired my Manta M5P board like shown in the manual.
I connected everything like shown in the Manual
Fan Jumpers on 24V
DIP Switch everything turned off
No Header in the USB Jumper.
Now the red P LED is just flashing but nothing happens. Also the PWR and ACT leds (which should indicate the CB1 i think) are completely off. When i am powering on the Bord then a green LED on the CB1 is flickering. After 30 Minutes i still dont have the CB1 in my Wifi.
Hi I finally wired my Manta M5P board like shown in the manual. I connected everything like shown in the Manual
Fan Jumpers on 24V DIP Switch everything turned off No Header in the USB Jumper.
Now the red P LED is just flashing but nothing happens. Also the PWR and ACT leds (which should indicate the CB1 i think) are completely off. When i am powering on the Bord then a green LED on the CB1 is flickering. After 30 Minutes i still dont have the CB1 in my Wifi.