search

bigtreetech / Raspberry-Pad

53 stars 12 forks source link

Control Display Backlight? #3

Open lalten opened 2 years ago

lalten commented 2 years ago

Hi, how can I control the Raspberry Pad 5's display backlight and power?

I'm on 2022-04-04-raspios-bullseye-arm64-lite with Kernel 5.15.32-v8+, running KlipperScreen (installed via kiauh)

❯ cat /boot/config.txt | grep "^\w"
dtparam=spi=on
dtparam=audio=on
camera_auto_detect=1
display_auto_detect=1
dtoverlay=vc4-kms-v3d
max_framebuffers=2
arm_64bit=1
disable_overscan=1
otg_mode=1
arm_boost=1
dtoverlay=dwc2,dr_mode=host
dtparam=i2c_vc=on
dtoverlay=i2c-rtc,pcf8563,i2c_csi_dsi

/boot/dt-blob.bin is also installed as per the manual.

A sysfs entry is present:

❯ ls /sys/class/backlight/10-0045/
actual_brightness  bl_power  brightness  device  max_brightness  power  scale  subsystem  type  uevent

But sending commands has no effect. (using rpi-backlight): sudo rpi-backlight -p off /sys/class/backlight/10-0045 Display stays on and at 100% brightness...

Darkgoppi commented 2 years ago

I have the same behavior as described by lalten. I tried to switch the back light power by manipulating the bl_power file in /sys/class/backlight/10-0045/ based on the status of xscreensaver. Is there any way to control the back light brightness and power?

Darkgoppi commented 1 year ago

Hi, I contacted the BIQU support on this issue/question. This is the answer from them:

"Sorry, no. This is a constant light that the screen lights up."

So it seems, that it is not intended to control the backlight at all, which is a pity.

sl1pkn07 commented 1 year ago

and via buttons hardware? (three in the corner)

kbenyous commented 5 months ago

Hi, I contacted the BIQU support on this issue/question. This is the answer from them:

"Sorry, no. This is a constant light that the screen lights up."

So it seems, that it is not intended to control the backlight at all, which is a pity.

Hello, According to their technical docs ( schematics https://github.com/bigtreetech/Raspberry-Pad/blob/master/Pad5/Hardware/BIGTREETECH%20Raspberry%20pad%205-SCH.pdf ) the 3 hardware buttons (BRI+, BRI- and LCD_DIR) are plugged to some pins of a ARM Cortex M0 MCU. So it could be software-controlled, if BTT would implement it in the firmware of this MPU !