search

bigtreetech / SKR-2

195 stars 178 forks source link

X-Axis endstop does not activate properly. #85

Closed T-SquaredProductions closed 3 years ago

T-SquaredProductions commented 3 years ago

I have been unable to get my SKR 2 to detect the X-axis endstop properly. I made multiple tests of the wiring, continuity, and checked for solder shorts. Everything looks fine visually.

The print head hits the endstop, but attempts to continue going. I have also used host software to check using the M119 command. It only shows an open circuit no matter if the switch is pressed or not, or even if I replace the endstop. (However, yesterday, Nov 7th, it showed a constant "TRIGGERED" state instead.)

I have checked my Marlin configuration, with no problems detected.

T-SquaredProductions commented 3 years ago

I got my wires mixed up. Everything is working now.