search

bigtreetech / SKR-3

158 stars 63 forks source link

SKR fails USB connect after sometime #62

Open yasaslive opened 1 year ago

yasaslive commented 1 year ago

All SKR boards I used failed on USB connection after using sometime. This issue present in all SKR models including SKR1.4 / PRO SKR3/PRO/EZ. No apparent cause found. No any connection whatsoever to raspberry. Thinking leaving BTT for MKS.

MagicPiciu commented 1 year ago

Same problem with me. Now I am looking for another board from another brand. After several searches on the Internet, I saw that it happens quite often with their motherboards.

yasaslive commented 1 year ago

What is you firmware Klipper/Marlin?

MagicPiciu commented 1 year ago

Klipper

dum., 28 mai 2023, 11:34 Yasas Alwis @.***> a scris:

What is you firmware Klipper/Marlin?

— Reply to this email directly, view it on GitHub https://github.com/bigtreetech/SKR-3/issues/62#issuecomment-1566040524, or unsubscribe https://github.com/notifications/unsubscribe-auth/A3QX6SXZVQNZVAX54U4BQNTXIMLZ5ANCNFSM6AAAAAAYQOOLKY . You are receiving this because you commented.Message ID: @.***>

yasaslive commented 1 year ago

If you are using Fluidd Try Mailsail! Some are having issues with Fluidd and it's deprecated!

MagicPiciu commented 1 year ago

I used Fluidd, Mainsail, Octoprint. It's the same for all: Klipper reports: ERROR mcu 'mcu': Unable to connect Once the underlying issue is corrected, use the "FIRMWARE_RESTART" command to reset the firmware, reload the config, and restart the host software. Error configuring printer

yasaslive commented 1 year ago

Yes, Exactly! I'm trying to use can over USB or UART for now until a new board arrives!

MagicPiciu commented 1 year ago

I'm trying to connect to CAN but I can't. I don't know what else to do. What motherboard did you order?