Open WilliamsPaulM opened 4 years ago
Board: SKR 1.4 Turbo Screen: TFT35-E3 V3
Pin Configuration: #define FIL_RUNOUT_PIN P1_26 // E0DET
When I plug the Smart Filament Sensor into Pin P1_26 it works perfectly in LCD Simulator Mode, but not in the Touch Screen Mode.
When I plug it into the FIL-DET pin on the TFT35 it works in the Touch Screen Mode, but not in the LCD Simulator Mode.
Is there a way to get it to work in both modes without moving the pin?
I followed the official steps from the BTT video on this sensor
I also enabled M114_DETAIL per the Manual
you need a y-Cable, where only the VCC goes to TFT Filament detectin Pin at TFT, Power and Ground from Board
Board: SKR 1.4 Turbo Screen: TFT35-E3 V3
Pin Configuration: #define FIL_RUNOUT_PIN P1_26 // E0DET
When I plug the Smart Filament Sensor into Pin P1_26 it works perfectly in LCD Simulator Mode, but not in the Touch Screen Mode.
When I plug it into the FIL-DET pin on the TFT35 it works in the Touch Screen Mode, but not in the LCD Simulator Mode.
Is there a way to get it to work in both modes without moving the pin?
I followed the official steps from the BTT video on this sensor
I also enabled M114_DETAIL per the Manual