I purchased a BTT ups 24v and a BTT SFS v2 for my ender 3 pro, however when looking at the wiring diagrams for both of these items they are to be plugged into the PWR-DET port. Can I use the Z-Endstop port, PC2 (not used as I also have a CR-Touch installed) for the SFS v2 and change the firmware so that PC2 is the filament runout and PC12 is the UPS? I would of course have to change out the JST to a 2 pin, but that is not an issue.
I purchased a BTT ups 24v and a BTT SFS v2 for my ender 3 pro, however when looking at the wiring diagrams for both of these items they are to be plugged into the PWR-DET port. Can I use the Z-Endstop port, PC2 (not used as I also have a CR-Touch installed) for the SFS v2 and change the firmware so that PC2 is the filament runout and PC12 is the UPS? I would of course have to change out the JST to a 2 pin, but that is not an issue.