furkanbalikci
commented
1 year ago Hello @Waltertscott10 ,
Thanks so much for your sharing. In my case it was /etc/asound.conf file instead of /.asoundrcfile. It may be because I did the sound setup with the https://wiki.seeedstudio.com/ReSpeaker_2_Mics_Pi_HAT_Raspberry/ guide. I recommend it for those who don't have much experience in this field. For this reason, I only had to change the audio device number and channel number in the ~/.pikrellcam/pikrellcam.conf file and set audio enable on.
Maybe this helps someone too :)
I had a breakthrough on this old issue with adafruit i2s mems mic you need to put the following into ~/.asoundrc
` /This section makes a reference to your I2S hardware adjust the card name / to what is shown in arecord -l after card x: before the name in [] /You may have to adjust channel count also but stick with default first
pcm.dmic_hw { type hw card sndrpii2scard channels 2 format S32_LE }
/This is the software volume control, it links to the hardware above and after / saving the .asoundrc file you can type alsamixer, press F6 to select / your I2S mic then F4 to set the recording volume and arrow up and down / to adjust the volume / After adjusting the volume - go for 50 percent at first, you can do / something like / arecord -D dmic_sv -c2 -r 48000 -f S32_LE -t wav -V mono -v myfile.wav
pcm.dmic_sv { type softvol slave.pcm dmic_hw control { name "Boost Capture Volume" card sndrpii2scard } min_dB -3.0 max_dB 30.0 }
/Automatic conversion plugin
pcm.dmic_plug{ type plug slave.pcm dmic_sv ` then in ~/.pikrellcam/pikrellcam.conf change
audio_device dmic_plugSorry about the indents i still don't know the proper syntax for this post :P I know that issue was closed but hope this helps someone :)