I am in the process of testing a new machine
After changing the information in the configuration file i performed the following operation
homed the x axis
then i ran a short gcode that moved 600mm and then returned 600mm
The x axis move past the 600mm mark and of course hit a hard endstop. and stalled the motors.
I then reset the board homed the x axis again this time i hit the reset button and then ran the gcode. this time the movements were as planned 600mm + direction and 600mm - direction
there seems to be a bit of a bug in the firmware.
I am in the process of testing a new machine After changing the information in the configuration file i performed the following operation homed the x axis then i ran a short gcode that moved 600mm and then returned 600mm The x axis move past the 600mm mark and of course hit a hard endstop. and stalled the motors. I then reset the board homed the x axis again this time i hit the reset button and then ran the gcode. this time the movements were as planned 600mm + direction and 600mm - direction there seems to be a bit of a bug in the firmware.