search

bitfocus / companion-module-canon-ptz

MIT License
11 stars 7 forks source link

Custom Trace issue with only two Presets and Pendulum selected #33

Open richardgatarski opened 10 months ago

richardgatarski commented 10 months ago

Using Companion 3.1.2, module v2.0.12, Camera set to N300 using port 80, polling set to 1000.

If I create a Custom Trace button with three Presets in a pendulum movement, it works works fine. If I then copy that Button and change the number of Presets to two, it will only trace to the second Preset and stop there. If I change the Loop mode from Pendelum to Normal it works as expected.

Even though Pendulum is perhaps not applicable when only two presets are used, I think it should not just stop.

Thanks.

josephdadams commented 10 months ago

What does it do if you make a new Custom Trace button with 2 presets? (not copying a 3)

richardgatarski commented 10 months ago

What does it do if you make a new Custom Trace button with 2 presets? (not copying a 3)

Sorry, I tried that but did not say. Anyways, same problem.