WPS (WIFI Protected Setup) is not supported or is disabled by the selected access point

[GoogleCodeExporter]

What steps will reproduce the problem?
1.Click on the AP
2.Click on WPS attack

What version of the product are you using? On what operating system?
I am Running backtrack 5 r3. i just updated the latest version of Fern

Please provide any additional information below.
At first i though it was my ralink RT3070 was at fault. But i try again on my 
RTL8187L which is proven to work before, also produced the same error msg.

Original issue reported on code.google.com by benjemin...@gmail.com on 10 Mar 2013 at 6:44

[GoogleCodeExporter]

is the target router WPS enabled..

Original comment by savioboy...@gmail.com on 11 Mar 2013 at 10:27

[GoogleCodeExporter]

hi 
i have the sam problem
and i need the solution for use the WPS Attack
i have a secound question, how i can download the dictionary file for the 
WPA/WPA2?

Original comment by medamine...@gmail.com on 5 Feb 2014 at 10:46

[GoogleCodeExporter]

did you make sure your reaver install works?
reaver version 1.4 from the debian repos did not work for me on wheezy. 
compiling the same version from source seems to work fine, also with fern. 
altough there is no output in the attack window like a status bar or the pin it 
tries, wireshark shows that the wps attack is working. anyway, how about maybe 
integrating bully, as it also supports brute forcing the last 4 digits of the 
pin?

Original comment by 5ch4...@gmail.com on 17 Feb 2014 at 4:47

[GoogleCodeExporter]

oops, status bar of course works, just did not wait long enough... 

Original comment by 5ch4...@gmail.com on 17 Feb 2014 at 5:01