Hi there! I was commited to flash a couple of wifi Nous A1 Smart Plugs but I saw the whole eletronics has been re-designed with a beken chip.
so far, based on my knowledge the only available way to flash with an open firmware is to use open-beken firmware.
however, the access to the classic tx,rx,3.3V, and gnd pins is quite complicated and requires de-soldering. on top of it, they used silicon adhesive paste to make the opening extremely difficult...with a real risk of ripping the whole electronic board apart.
considering that, I did not flashed those that I bought...
with that said, I guess a sort of warning should be posted....
no issues of course for the A1T model...those which are coming pre-flashed with Tasmota....
Hi there! I was commited to flash a couple of wifi Nous A1 Smart Plugs but I saw the whole eletronics has been re-designed with a beken chip. so far, based on my knowledge the only available way to flash with an open firmware is to use open-beken firmware.
however, the access to the classic tx,rx,3.3V, and gnd pins is quite complicated and requires de-soldering. on top of it, they used silicon adhesive paste to make the opening extremely difficult...with a real risk of ripping the whole electronic board apart. considering that, I did not flashed those that I bought...
with that said, I guess a sort of warning should be posted.... no issues of course for the A1T model...those which are coming pre-flashed with Tasmota....