Repair report

[rwaldron]

Reconbot 3

• Rewired dir pin;
  • 7 -> 12
• Repaired voltage regulator
  • reconnect V to barrel, retighten screw
  • re-sheathed with shrink wrap
• Stress tested battery hookups
• Fastened tilt arm assembly to servo horn with super glue
• Fastened camera to tilt arm assembly with super glue
• Deployed via git (this one is not connected to resin)

  Reconbot 4 (This connected to resin, even though resin says "reconbot-5")

• Rewired dir pin;
  • 7 -> 12
• Repaired motor/servo power harness
  • soldered wire to battery connector pins
• Stress tested battery hookups
• Fastened tilt arm assembly to servo horn with super glue
• Fastened camera to tilt arm assembly with super glue
• Deployed via resin

  Reconbot 5

• Rewired dir pin;
  • 7 -> 12
• Repaired motor/servo power harness
  • soldered wire to battery connector pins
• Stress tested battery hookups
• Gets stuck here:

 Application available at (physical) address 0x04819000
        VRL mapped to 0xff213000
        App size = 11508 bytes

        App Authentication feature is disabled!
        Resetting IPC

*** Ready to receive application ***

Reconbot 2

• Rewired dir pin;
  • 7 -> 12
• Repaired voltage regulator
  • replace battery connector
  • re-sheathed with shrink wrap
• Stress tested battery hookups
• Cannot deploy
• Cannot connect via serial/screen (over usb)

[rwaldron]

cc @reconbot

[reconbot]

Where is 1?

[reconbot]

Checklist for myself

• [x] Glue the remaining servo horns
• [x] Replace or figure out what's up with the edison on reconbot 2
• [x] Flash reconbot 2
• [x] Flash reconbot 5
• [x] Get the deploy and device naming straitened out for all bots
• [ ] Figure out wifi configuration steps for the show
• [ ] Figure out how we should do the ip address discovery for the bots
• [ ] Test booting all the bots and driving them all around

[rwaldron]

Where is 1?

I had to poach parts from it.

Figure out wifi configuration steps for the show

Can't we just create a same named AP & password (same as we used in SF)?

[reconbot]

I'll preconfigure a wifi configuration but I want to have a procedure to change it without internet access.

On Tue, Sep 27, 2016, 2:36 PM Rick Waldron notifications@github.com wrote:

Where is 1?

I had to poach parts from it.

Figure out wifi configuration steps for the show

Can't we just create a same named AP & password (same as we used in SF)?

— You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub https://github.com/bocoup/reconbot/issues/4#issuecomment-249956561, or mute the thread https://github.com/notifications/unsubscribe-auth/AABlbv2_Houp5KrUIwnUlaI04J7CGVPxks5quWITgaJpZM4KFWke .

[rwaldron]

Got it.

[reconbot]

I packed

• the 5 bots (we'll use #1 as a display)
• 4 sets of lipo batteries (all I could find)
• The blue lipo charger (I couldn't find it's power supply)
• Graph tape, the caution tape, double sided tape, velco tape
• all the stickers and tshirts we have (less than Bay Area)
• USB Power Strip
• Two stamps, one Bocoup one Johnny-Five
• Some markers

We can goto staples and print/laminate some placecards describing the origin story and our 1 pager.