search

bootuz-dinamon / ender3-v3-se-full-klipper

Configuration files for Klipper for Ender3 V3 SE.
135 stars 17 forks source link

wled how to? not an issue just asking for help #12

Open SPYKE357 opened 5 months ago

SPYKE357 commented 5 months ago

good morning

i have this branch of klipper on my se and saw that there's a wled config, how is it controlled and wired up, would like to do the same to have a controllable caselight if possible.

your help will be greatly appreciated.

Furthermore, thank you very much for this build. been very happy with it since release.

bootuz-dinamon commented 5 months ago

Information on how to connect and use wled can be found in the moonraker documentation.

SPYKE357 commented 5 months ago

Information on how to connect and use wled can be found in the moonraker documentation.

Thank you, but how do you wire it up? the moonraker config seems easy enough but i have no idea how to wire the strip to the printer to enable control over moonraker.